Sovol SV08 BTT Octopus Pro Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Mounts the BTT Octopus Pro controller equipped with @DETMan's mount in between the two 2020 extrusions under the frame.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 0
- Makes
- 0
- Views
- 33
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
designed to work in conjunction with the Big Tree Tech Octopus Pro ducted fan mount at
This was created to enable the use of this mount for a Sovol SV08 rebuild, to place the octopus pro control board and a buck connector in between the two 2020 extrusions which run under the frame of the printer. This lets you neatly arrange your electronics and leave plenty of room for neat cable runs, clear labels and good airflow.
The two plates interlock, the right side takes two M3x5mm heat inserts and you will need some washers to fasten the left side to the right. You will print the brackets for the extrusions which each take three M3x5mm heat inserts and then the hexagon plate for the Octopus Pro mount takes eight M3x5mm heat inserts for the mount by @DETMan
Mount the bottom plate of Octopus Pro ducted fan mount to this new mount first, then install the Octopus Pro control board and then when you fit the duct and fan mount to it, there are large holes underneath this mount so you can fasten the screws which pass from the bottom and up into the fan duct. Then you mount the entire assembly to the two 2020 extrusions under the printer and secure with M4 T-nuts.