1 / 3
Philips FC8132 EasyLife floor nozzle wheel (replacement) — image 1
1 / 3

Philips FC8132 EasyLife floor nozzle wheel (replacement)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Replacement roller wheel for the Philips FC8132/01 EasyLife vacuum floor nozzle. Prints flat, no supports.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
8
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Replacement for the small rear roller wheels on the floor nozzle (the hose attachment that slides on the floor) of the Philips FC8132/01 EasyLife bagged vacuum cleaner. The size and fit are tested on an FC8132/01 nozzle.

Dimensions

  • Outer diameter: 22 mm

  • - Width: 8 mm at the tread, 9 mm at the hub

  • - Bore: 4.0 mm, with lead-in chamfers on both ends

Fitting

The wheels spin on the existing pin in the nozzle. Put the flat side, with the bevelled tread edge, towards the nozzle body. The hub sticks out 1 mm on the other side and acts as a spacer. If a wheel rubs, flip it over.

Designed for printing

Every part of the wheel starts on the bed: rim, web and hub. The bottom tread edge is a 45 degree bevel instead of a rounding, so it prints without supports, bridges or overhangs.

Files

  • STL: two wheels, laid out ready to print

  • - 3MF: PrusaSlicer project with the print settings attached to the object

  • - SCAD: parametric OpenSCAD source. Change the diameter, width, bore or clearance to fit similar Philips nozzles. It also has optional extras: an O-ring groove for a softer tread, grip ribs, and a version with clip-in pins (the pin version is untested and needs supports).

Other models

Other Philips EasyLife models (FC8130 to FC8139) probably use the same nozzle, but only the FC8132 is tested. Measure your old wheel first, and adjust the SCAD file if needed.

Print settings

PLA or PETG, 0.15 mm layers, 4 perimeters, 100% infill, no supports, no brim. About 35 minutes for two wheels on a Prusa MINI+.

After printing

If the wheel is tight on the pin, push a 4 mm drill bit through the hole by hand.

Tags