Cable Modem Mounting Bracket Motorola / Arris SurfBoard

FYI the fit on this isn't great - I noticed recently the measurements have been off for this model as well as others (not sure if it's always been that way or if Arris switched things a bit). Use this new model instead https://www.printables.com/model/378645-arris-surfboard-sb8200-mount

To address this I've redesigned this part from scratch and will be posting it as a new design soon. 

Original credit goes to: https://www.youmagine.com/designs/surfboard-sb6141-mounting-bracket (jbolonski).

• 6141_Mount.stl: Original from the site above
• 6141 Mount 4mm Base Depth.stl: additional 1mm of base and screw holes are converted to fit a small sheet metal screw instead of a beveled screw. Screw holes are slightly larger for better fitment. 4mm plate thickness, 3mm screw head depth, and 1mm of base to have the screw hold (screw holes are slightly larger than the 5mm stl file and will fit a small piercing sheet metal screw).
• 6141 Mount 5mm Base Depth.stl: Thicker base and screw holes are converted to fit a small sheet metal screw instead of a beveled screw. 5mm plate thickness. 3mm screw head depth, and 2mm of base to have the screw hold.

Print instructions

Category: Organization Print Settings

Printer Brand: Ultimaker

Printer: Ultimaker 3

Rafts: Doesn't Matter

Supports: No

Resolution: .2

Infill: 10%

Notes:

ran at draft/high speed and quality of the main part was fine for it's intended purpose, HOWEVER, the bump outs were not precise enough (they were a little off center and warped). I recommend printing those layers at a much lower speed - I'll try another print at a slower speed to compare the quality.