1 / 5
CORAL LOFT - Single & Trio Coralboard SL Cases — image 1
1 / 5

CORAL LOFT - Single & Trio Coralboard SL Cases

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Passive enclosure for 1-3 Coralboard SL boards. Single + Trio CAD prototypes, assembled without extra fasteners.

Rating
0 / 5
Likes
2
Downloads
3
Makes
0
Views
33
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial — Share Alike

CORAL LOFT is a server rack inspired enclosure for the Synaptics Coralboard SL. It houses one board in the Single version and up to three boards in the Trio version. Both share a rounded shell, closed front, angled roof louvers and rear cable openings. The boards stand vertically with USB connections facing the rear.

The design uses passive ventilation - the cooling performance has not been measured though.

Fit still needs physical validation as I did not have a coralboard on hand!

What to print

Single: 3 parts, 60 x 115 x 120 mm assembled.

  • CORAL_LOFT_Single_Base.stl

  • CORAL_LOFT_Single_Shell.stl

  • CORAL_LOFT_Board_Carrier.stl

Trio: 5 parts, 140 x 115 x 120 mm assembled.

  • CORAL_LOFT_Trio_Base.stl

  • CORAL_LOFT_Trio_Shell.stl

  • CORAL_LOFT_Board_Carrier.stl (three copies)

STL, STEP and 3MF files are supplied for each part. STEP assemblies are also included for Single and Trio. The 3MF files are geometry exports, not validated printer profiles or sliced print jobs.

Print settings

Suggested settings: 0.4 mm nozzle, 0.20 mm layers, 4 walls and 15-20% infill where applicable. Use settings suited to your filament and printer. Use auto generated support.

Assembly

1. Inspect the printed parts and remove strings or burrs from mating surfaces.

2. Place the board on the carrier's four local supports, engaging the two locating pins. Release the two retaining clips into position. Keep pressure off chips and connectors. The PCB must sit flat without bending.

3. Lower the carrier's two feet into the base sockets. These feet guide the carrier - they do not latch it into the base. Repeat for the other carriers for the Trio version.

4. Connect required cables and route each board's cables through its own rear channel.

5. Lower the shell and engage its two base latches. Internal shell ribs limit carrier lift with a nominal 0.3 mm clearance. They act on the carrier - not on the electronics. No additional screws, magnets or adhesive is required.

6. Check seating, cable clearance. Validate temperatures under your intended workload before extended use.

Opening and Access

Disconnect power before working on the electronics. Release both shell latches and lift the shell straight upward. Hold the carrier frame when releasing the board clips.

The removable shell and carrier provide access to microSD and development connectors. Compatibility with additional modules, ribbon cables and oversized plugs requires a separate fit check.

Tags