Quick-Release Adapter Clip for Retractable Tape Measure Tether
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
adapter clip
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 4
- Makes
- 0
- Views
- 64
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Garage
- License
- Open Community License v1.1 + General Attribution v1
Replacement quick-release adapter clip for retractable tape measure tethers and heavy-duty badge/tool reels (compatible with systems like Gear Keeper, T-Reign, and similar retractable tool holders).
If the original plastic locking adapter on your tape measure broke or you need an extra mounting clip for a second tape measure, this model serves as the male quick-disconnect connector that snaps directly into the tether mechanism.
Purpose: Replacement male connector for retractable tape measure holders / tool tethers.
Mounting: Features a countersunk center hole for securing directly to the tape measure housing or clip slot.
Print Settings Recommendations:
Material: PETG, ABS/ASA, or Tough PLA/PLA+. PETG or ABS is strongly recommended for the locking tabs to prevent snap-off under repeated tension.
Wall Loops / Perimeters: 4–5 walls for structural rigidity around the screw hole and side locking grooves.
Infill: 40–60% (Gyroid or Grid).
Layer Height: 0.16–0.20 mm for clean alignment edges.
Supports: Print flat on its back; usually requires no supports depending on hole overhangs.
