1 / 1
Quick-Release Adapter Clip for Retractable Tape Measure Tether — zdjęcie 1

Quick-Release Adapter Clip for Retractable Tape Measure Tether

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

adapter clip

Ocena
0 / 5
Polubienia
1
Pobrania
4
Wydruki
0
Wyświetlenia
51
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Garage
Licencja
Open Community License v1.1 + General Attribution v1

Replacement quick-release adapter clip for retractable tape measure tethers and heavy-duty badge/tool reels (compatible with systems like Gear Keeper, T-Reign, and similar retractable tool holders).

If the original plastic locking adapter on your tape measure broke or you need an extra mounting clip for a second tape measure, this model serves as the male quick-disconnect connector that snaps directly into the tether mechanism.

  • Purpose: Replacement male connector for retractable tape measure holders / tool tethers.

  • Mounting: Features a countersunk center hole for securing directly to the tape measure housing or clip slot.

  • Print Settings Recommendations:

    • Material: PETG, ABS/ASA, or Tough PLA/PLA+. PETG or ABS is strongly recommended for the locking tabs to prevent snap-off under repeated tension.

    • Wall Loops / Perimeters: 4–5 walls for structural rigidity around the screw hole and side locking grooves.

    • Infill: 40–60% (Gyroid or Grid).

    • Layer Height: 0.16–0.20 mm for clean alignment edges.

    • Supports: Print flat on its back; usually requires no supports depending on hole overhangs.

Tagi