1 / 4
Add-On Handle for Sliding Windows & Patio Doors (Screw-Mount, Printable Without Supports) — image 1
1 / 4

Add-On Handle for Sliding Windows & Patio Doors (Screw-Mount, Printable Without Supports)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A simple, sturdy add-on handle that gives you a comfortable grip on sliding doors, window sashes and patio doors.

Rating
0 / 5
Likes
1
Downloads
3
Makes
0
Views
20
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — NoDerivatives

Do you have a sliding door or window that is hard to grab, because the frame is flat and has no handle? This handle solves the problem.

It has a flat base with a raised rail/guide on the back that sits against the frame, and a rounded grip tab that sticks out so your fingers can pull or push the sash easily. The corners are rounded and smooth, so it is comfortable to use and doesn’t catch on clothes.

Features

  • ✅ Fixed with 2 screws through countersunk holes, so it stays firmly in place

  • ✅ Rear ribs and channels for a stronger part and less material

  • ✅ Rounded, ergonomic grip tab

  • ✅ Prints without a complicated setup

  • ✅ Tested on a real door (see photos: printed in white and mounted on a white PVC frame)

Recommended print settings

  • Material: PETG or ASA (recommended for sun exposure and temperature changes); PLA works indoors

  • Layer height: 0.2 mm

  • Infill: 30–40%

  • Walls/perimeters: 3–4

  • Supports: [yes/no]

  • Print orientation: [flat on the bed with the grip facing up / other]

  • Colour: white to match PVC frames, but any colour works

Hardware needed

  • 2 × screws, [e.g. 3.5 × 16 mm countersunk or similar, adapt to your frame]

  • Optional: double-sided tape or a drop of glue for extra hold

Installation

  1. Check the position on your frame and mark the two holes.

  2. Pre-drill if your frame material needs it.

  3. Fix the handle with the two screws without over-tightening.

  4. Done!

Customization
The measurements may differ from one window to another. Measure your profile before printing. If you need a different size, leave a comment and I’ll try to help. Feel free to post a “Make” with your photos!

Tags