Slimagotchi with Waveshare 2.13 inch e-ink display and Geekworm X306 v1.5 battery case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case for the Slimagotchi hardware mod, with Geekworm X306 and Waveshare 2.13-inch V4 display.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 3
- Makes
- 0
- Views
- 22
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This case adapts Pwnagotchi Super V19 to fit the Slimagotchi hardware mod, which makes the Pwnagotchi hardware smaller. It is designed for a Raspberry Pi Zero 2 W, Geekworm X306 V1.5 and Waveshare 2.13-inch V4 display.
Files
Print one base and one lid. The STLs are in millimetres and already oriented for printing. A rendered view is included in the photos.
Hardware
2 × M2 × 10 mm socket-head screws to close the case from underneath on the port side.
4 × M2.5 × 5 mm socket-head screws to attach the X306 to the base, replacing its bottom screws.
Printing
Print the base floor-down, with supports for the six bottom holes and the side USB opening.
Print the lid in the supplied orientation, with the seam side down. Use supports throughout the interior, but block supports in the small holes: they are too difficult to remove from those openings.
Assembly
Install the Pi, X306 and display stack with the battery fitted. Attach the X306 to the base with the four M2.5 screws. Hook the lid onto the battery-side rail and swing it closed, then fasten the two M2 screws from underneath. Check the display, flex cable, button and ports for clearance without forcing the parts.