DeLonghi water dump - Redesigned
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
DeLonghi water dump redesigned so that it can be printed without splitting or supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 5
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I printed the original and found it a very nice idea, but I had problems printing the overhangs of the fixation. Even when splitting the part in two and adding connectors as suggested.
Using it, discovered that after an off-on cycle it gets quite full. Also the base is quite small and is easy to spill water with a small bump.
So, I redesigned the original part to improve these aspects. The main goal was to have a design that can be printed without supports, on any printer.
This part is now 120mm wide, instead of the original 80-90mm, to ensure it does not fill too close to edge.
Printed in PETG, 3 perimeters and 0.2mm layers.
I am publishing also the STEP file in case someone want to make additional improvements.