Meshtastic Faketec V4 Tube Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A mount for installing a compact Meshtastic node inside a 26.5mm-diameter aspirin bottle.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 26
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
A mount for installing a compact Meshtastic node inside a 26.5mm-diameter aspirin bottle.
The aim was to make use of an empty, cleaned-out aspirin bottle to house a compact node based on the Faketec V4, using an 18650 battery holder.
In the end, I also ended up printing the casing in two lengths: a long one to house the node mount – which uses a ‘spaghetti’ antenna – and an 18650 battery in a standard AliExpress battery holder; and a shorter one, ideal for a 16340 battery I had lying around at home.
Given the RA-62’s low power consumption, a 700/900mAh battery is more than enough.
The bracket has two 2mm holes for fitting short M2 screws, 3 or 4mm long, to secure the plate in place. They are screwed directly into the plastic; nothing else is required.
Antenna: A ‘spaghetti’ antenna fitted either directly on top or underneath, where there is space to route the battery cables. It’s not ideal, but everything fits. (I used this one -not affiliated- https://es.aliexpress.com/item/1005006099597672.html)
Battery holder:
I used this one for the 16340 battery https://www.printables.com/model/1246715-battery-holder-cr123a-rcr123a-16340
I used this one for the 18650 battery, but it's a tight fit (not affiliated) https://es.aliexpress.com/item/1005005084346241.html
The entire print job can be carried out without supports.