Replacement bridge deck for Step2 Fill and Dump mine-cart table
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Recharge the play value in your old mine cart toy from Step2 - replacement bridge decks make the cars go again
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 5
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Toys
- License
- Creative Commons — Attribution
I noticed that the fill and dump table wasn't getting much play time in the preschool. So I replaced the missing bridge decks that let the little mine carts drive around. Suddenly the kids are playing with it again. A little attention and the play-value of the toy is restored.
Printing instructions
USE PETG (PLA degrades when exposed to water, and is quite brittle).
Settings - 0.25 layer height (speedier, thicker layers), 4 perimeters (for strength), 1 extra top and bottom layer (for stiffness) and 15% grid infill.
It's an easy print, no supports are required. Just bed it flat side down. I printed them in bright colors to match the original color scheme of the toy. I didn't tell the kids it was fixed up - they just started playing with it again. Now it needs a good cleaning.