Tiny ESP DeskBuddy case for Waveshare ESP32-C6 1.47in LCD
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Palm-sized shell that turns the Waveshare ESP32-C6-Touch-LCD-1.47 into a desk buddy with a face, clock and weather.
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 13
- Makes
- 0
- Views
- 69
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution
A palm-sized shell for the Waveshare ESP32-C6-Touch-LCD-1.47 that turns the board into a desk buddy: a black-and-white face with two tall white eyes, plus swipeable pages for time, date, weather, moon phase, a stock quote and GitHub stats.
Tap the face to cycle through five expressions. Tilt it and the eyes drift, driven by the board's onboard QMI8658 IMU. The display, touch controller and IMU are all on the Waveshare board, so there is no wiring. The only extra part is a small LiPo.
The photos show the printed shell; the screen in them runs a different sketch from the guide's firmware. The last two photos are the guide's unmodified firmware running on a real board, filmed on 28 Oct 2026. Left alone, it blinks and glances around, then flips to the clock and the date every 8 seconds. The clock counts up from the moment the firmware was built; the code does not sync time over Wi-Fi. Weather comes from Open-Meteo, the stock page shows AAPL from Stooq, and without Wi-Fi details the network pages show a setup message.
Parts
1 × Waveshare ESP32-C6-Touch-LCD-1.47 (ESP32-C6, 1.47in 172 × 320 IPS LCD, capacitive touch, USB-C, battery connector, QMI8658 IMU)
1 × 3.7 V single-cell LiPo with a plug for the board's battery connector (the guide lists a 400 mAh cell; 300–500 mAh is the suggested range)
Printing
One part: tinyespdeskbuddy.stl, 46.7 × 26.8 × 21.4 mm. OrcaSlicer 2.4.2 estimates 11 min 55 s on a Bambu Lab P1S (0.4 mm nozzle, 0.20 mm Standard, Bambu PLA Basic, auto-orient, no supports, 20% infill). The mesh is 165 separate shells and isn't watertight; it slices cleanly as is. PLA or PETG both work.
Assembly
Set your Wi-Fi name, password and GitHub username at the top of the sketch, then flash it from Schematik's Deploy panel. Leave them blank and the face, clock and date still work.
Enable CDC on Boot, or the serial monitor stays empty over the native USB-C port.
Plug the LiPo into the board's battery connector and tuck the cell behind the display module. Don't pinch or puncture it when you close the shell.
Press the board into the open front of the shell, screen facing out, with the USB-C port reachable for charging and reflashing. The photos show the order: battery in, board pressed in on top.
Full guide with firmware, pin table and flashing steps: https://www.schematik.io/projects/build-an-esp-c6-touch-lcd-gadget
Firmware and wiring guide generated with Schematik, our AI hardware tool; the enclosure was modelled by hand.