Crown Victoria Key Fob / Grand Marquis Key Fob / Marauder Key Fob / Ford Key Fob
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Key fob for Crown Victoria Key Fob / Grand Marquis Key Fob / Marauder Key Fob, should fit any ford key of that era
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 7
- Makes
- 0
- Views
- 42
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
Basic Info
ASA/ABS filament for vapor smoothening (can use any filament but asa or abs will be needed if you want it glossy smooth)
3m heat inserts + 3m x6mm bolts (x2 of each)
1 inch key ring (x1)
.15 mm layer hight
no supports for back, please modify supports so none generate inside the key ring
was made for my grand marquis but i could not get the grill to look right so i made the front end of a crown vic and added a marauder wing
heavily edited the following files and used them as a base to make this
Credits
model used for design (not 3d printable)
L95XP
https://sketchfab.com/3d-models/mercury-grand-marquis-free-0f9e6281fd6b4c7a8c5c9de957ccf5a5
For key fob
https://www.printables.com/model/748854-ford-key-fob-case-front
the sizes are 111.6 mm and 102.7 mm long, the bigger print was the first print but i felt as it was too big so i tried to make it as small as possible while still being proportionally a crown vic i cannot make it any smaller due to the internals of the key fob, this design should fit any ford with this key fob which i think nearly all of them had