1 / 5
SKADIS Ball Vise - mini vise on a lockable ball joint for your pegboard (100% printed) — image 1
1 / 5

SKADIS Ball Vise - mini vise on a lockable ball joint for your pegboard (100% printed)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Mini vise on a lockable ball joint for your IKEA SKADIS board. Tilt, turn and lock it with one twist of the collar.

Rating
0 / 5
Likes
52
Downloads
69
Makes
0
Views
383
Reviews
0

Updated at source:

Model information

Category
Tools
License
Creative Commons — Attribution — Noncommercial — Share Alike

Hold a PCB, a model, a small part or anything else up to 45 mm wide right where you need it. Loosen the big collar, tilt and turn the vise to any angle and tighten the collar again to lock the ball. The vise sits off the desk on your SKADIS board, so it takes no space on your bench.

  • Jaws open from 0 to 45 mm

  • Ball joint tilts about 37 degrees in every direction and turns 360 degrees

  • One collar locks the ball, no tools needed

  • Jaws have a horizontal and a vertical V-groove for round parts, rods and PCBs

  • Hangs on SKADIS with four printed clips, they slide into the back of the bracket

  • Fully printed: all threads (M10, M16, M20 and M56) and nuts are printed, no metal hardware needed

Not tested yet - designed and checked in CAD (all threads and parts checked for fit and clearance, including the full tilt range).

Tags