SKADIS Ball Vise - mini vise on a lockable ball joint for your pegboard (100% printed)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mini vise on a lockable ball joint for your IKEA SKADIS board. Tilt, turn and lock it with one twist of the collar.
- Ocena
- 0 / 5
- Polubienia
- 38
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 217
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hold a PCB, a model, a small part or anything else up to 45 mm wide right where you need it. Loosen the big collar, tilt and turn the vise to any angle and tighten the collar again to lock the ball. The vise sits off the desk on your SKADIS board, so it takes no space on your bench.
Jaws open from 0 to 45 mm
Ball joint tilts about 37 degrees in every direction and turns 360 degrees
One collar locks the ball, no tools needed
Jaws have a horizontal and a vertical V-groove for round parts, rods and PCBs
Hangs on SKADIS with four printed clips, they slide into the back of the bracket
Fully printed: all threads (M10, M16, M20 and M56) and nuts are printed, no metal hardware needed
Not tested yet - designed and checked in CAD (all threads and parts checked for fit and clearance, including the full tilt range).