Rear Axle For Toy Remote Control Car - Compatible with Carrera RC MarioKart
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Quick mockup of the rear axle for the Mario/Luigi Carrera RC remote control cars.
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 74
- Makes
- 0
- Views
- 611
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Mechanical Parts
- License
- Creative Commons — Attribution
Someone tripped over one of our RC cars at a birthday party and broke the axle. Rather than toss it or use it for parts, I decided to try to model and print a replacement. The cube that makes the U-joint was still whole, so I haven't modelled it. A 9.8 mm cube with 2.5mm holes on 4 of the faces would be a good replacement (2 holes through the cube). The rods are 2.5mm diameter chromed metal with a knurl on one end, 2 of the rods are 5.8mm, the other is 15.6mm in length.
Depending on your printer's tolerance, you may need to hand ream the pin holes with a 2.5mm drill bit. Alternatively, a 5/16" drill bit works well.
Print Directions: Use build plate supports and a structural, impact-resistant plastic, like Nylon, PC, or ASA/ABS at 100% infill.
Sliced for 0.4mm nozzle on Prusa i3 MK3S+ with MMU2S at 100% infill using Spool3D PC Filament (230 hotend, 115 heatbed).
Update 09-04-22: Added cube for middle of CV axle.