Rear Axle For Toy Remote Control Car - Compatible with Carrera RC MarioKart
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Quick mockup of the rear axle for the Mario/Luigi Carrera RC remote control cars.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 607
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution
Someone tripped over one of our RC cars at a birthday party and broke the axle. Rather than toss it or use it for parts, I decided to try to model and print a replacement. The cube that makes the U-joint was still whole, so I haven't modelled it. A 9.8 mm cube with 2.5mm holes on 4 of the faces would be a good replacement (2 holes through the cube). The rods are 2.5mm diameter chromed metal with a knurl on one end, 2 of the rods are 5.8mm, the other is 15.6mm in length.
Depending on your printer's tolerance, you may need to hand ream the pin holes with a 2.5mm drill bit. Alternatively, a 5/16" drill bit works well.
Print Directions: Use build plate supports and a structural, impact-resistant plastic, like Nylon, PC, or ASA/ABS at 100% infill.
Sliced for 0.4mm nozzle on Prusa i3 MK3S+ with MMU2S at 100% infill using Spool3D PC Filament (230 hotend, 115 heatbed).
Update 09-04-22: Added cube for middle of CV axle.