1 / 6
Prusa Core One exhaust energy capture with efficient turbine — image 1
1 / 6

Prusa Core One exhaust energy capture with efficient turbine

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Efficient turbine capturing energy from exhaust of Prusa Core One. Spins efficiently with minimal air leakage.

Rating
0 / 5
Likes
7
Downloads
16
Makes
0
Views
399
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial

The quest to infinite energy! 

This is an air turbine that spins using the exhaust air from the Prusa Core One. It spins efficiently and is designed to minimize air leakage. It spins a rotor, that has gear on the outside, allowing you to spin or move something. The videos shown is the stock Prusa Core one exhaust running at default (55%) speed.

There are 2 parts:

  • Turbine

  • Transmission (14x torque)

This idea started because of the Prusa Core One skin contest. All the skins were static. I wanted to design something that moves, without using electronics. Can't wait to see what everyone builds with this.

Note: There WILL be air leakage, so its not suitable for use with material with toxic emission
Note2: This WILL reduce the exhaust air speed. Test before using!

Note3: This mounts directly on this exhaust elbow, and the top fits the 100mm duct

Transmission assembly

1x transmission_base_plate

1x transmission_gears

2x transmission_shaft_flushed

1x transmission_shaft_long

(Picture shows 2 long shaft. 1 will do)

1x transmission_top_plate (your choice)

6x 688 bearings (bought or printed)

  • Place 688 bearing in the slots

  • The big gears are labeled A, C, E.  The small pinion gears are labeled [ . ] [ . . ] (dots)

    • 1st gear set - assemble from bottom up;  FLAT side of gear facing UP;

      • use shaft_flushed , gear A -> pinion [ . ]  (silver gear and gold pinion in picture)

    • 2nd gear set - assemble from bottom up;  FLAT side of gear facing UP;

      • use shaft_flushed, gear C -> pinion [ . . ] (silver gear and silver pinion in picture)

    • 3rd gear set - FLAT side of gear facing UP;

      • use shaft_long, gear E (gold gear in the picture)

  • Place in 688 bearing slots as per the picture. 

  • Place 3x 688 bearing into the top plate slots and cover accordingly.

  • There are optional feet pieces to be printed in TPU for the base plate. It should sit on the top of the Prusa Core One without them. Adding some TPU feet might reduce vibration sounds if you face any.

Completed transmission assembly

Turbine assembly

  • 1x pin - note the difference in length at the 2 ends 

  • 1x lower housing - insert the SHORT end into the lower housing. It should go in up till the collar on the pin

  • 1x turbine rotor, 2x 688 bearings - place the bearings in the slots

  • Assemble in order Lower Housing -> Transmission assembly -> Turbine Rotor -> Upper housing

Completed assembly

THERE SHOULD BE MINIMAL GAP BETWEEN [Lower] - [Turbine] - [Upper]  to minimize air leakage

Mods

The top plate has screw holes to hold whatever decorations you can design, to connect to the spinning rods. 

Tags