1 / 21
FlySky FS-G11P Thumb System
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
FlySky FS-G11P Thumb Wheel SystemRequirements:1x M3 countersink ± 10 mm (lock ring)2x M3 screws to adjust/reduce angle…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 3
- Makes
- 0
- Views
- 21
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial
FlySky FS-G11P Thumb Wheel System
Requirements:
- 1x M3 countersink ± 10 mm (lock ring)
- 2x M3 screws to adjust/reduce angle as required (Make sure the screws are nicely flat where they touch the angle bar)
- Optional: 8x M2x6 for the cover plate
- !Recalibrate after any change/screw angle bar adjustment! (as documented in the manual)
- Needle file for finish
Features:
- Supports decrease of wheel default angle (35 degrees) same as stock wheel
- Supports adjustability via lock ring as required
- Knurled surface for good grip
- Includes different designs with different sizes
- Includes a custom toggle knob to increase thumb area when steering
- v4 provides 2 sizes (Long 28mm vs Short 24mm with a difference of about 4mm) including an optional cover plate
Why use thumb steering?
- One hand free to do any other task
- More relaxed driving experience once the muscle memory has adapted
- Catch your crawler when it falls.
- Put one hand in your pocket if it's cold outside.
How to:
- Use small custom knob to increase thumb space (the knob fits tighter as the original knob).
- Use base wheel to support ring system
- Print desired ring(s) as required
- Optional: Provide constructive feedback to improve the system
Printing:
- Base wheel does NOT require any support or brim (at least mine was working without)
- Ring 6, 7, 8 require tree support on little knob (Use brim for the rings if they move while printing)
- I used "simple" PLA and PETG
Finish:
- Make sure the ring on the main wheel has a nice finish to support the lock system as good as possible
- Use needle file to finish the toggle knob BEFORE attachment using force
Final thoughts:
- The FlySky FS-G11P compared to FS-G7P (https://www.thingiverse.com/thing:7266144) was simpler to create a comfortable thumb system because the wheel axle is close to a comfortable thumb position
- Any increase of the thumb piece radius increases the thumb way, which we usually don't want, even if this system allows it to reduce the default 35 degree angle
- Reducing the default 35 degree angle too much might lead to a lack of steering sensitivity when using the wheel to steer (for example, in case of 4 wheel steering)
- I prefer the "ThumbRing_8-" version with a slightly reduced wheel angle via adjustment screws. This way the thumb can go the entire way as comfortably as possible while steering via wheel still provides sufficient sensitivity
Category: 3D Printing