Inverted Squeeze Bottle Rack ×6 with Drip Tray (restaurant/kitchen)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holds six 55-60 mm squeeze bottles cap-down over a removable drip tray. Lightweight open frame. No supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 4
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Inverted Squeeze Bottle Rack x6 with Drip Tray, designed by Kalfa Garage.
Holds six standard catering squeeze bottles (55-60 mm, e.g. 24 oz / 700 ml) cap-down in a 2 x 3 grid over a removable drip tray. Cap-down means the sauce is always at the nozzle: no shaking, no air burps during service, the last of each bottle gets used, and drips land in the tray, not on the counter.
Details: 62 mm bores with a flared lead-in, 45-degree seats, 34 mm cap holes, fill-level windows in every cell. The rack sits over the tray lip so it stays located. Lightweight open-frame v2 design.
Parts: rack_v2.stl (206 x 138 x 52 mm) and drip_tray_v2.stl (206 x 138 x 53 mm). Both fit a 256 x 256 bed.
Print settings: PETG recommended. 0.2 mm layers, 0.4 mm nozzle, 2 walls, 15% infill. No supports: print both parts upright as exported (rack with its seats on the bed, tray with its floor down). Smooth PEI plate with glue stick recommended.
Estimates from the mesh (not sliced): rack about 130 g, tray about 109 g, total about 240 g and roughly 7-11 h. Slice it for real numbers. Nozzle room under the shoulder is about 59 mm, enough for a typical cap and nozzle.
Note: the image is a render, not a photo of a print. Made with AI-assisted tools.