Post Cover 70x70 and 90x90
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A post cap with a ball as a design element.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 5
- Makes
- 0
- Views
- 36
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Share Alike
As I was missing a post cover, rather than buying one, I designed and printed one.
My post is 70x70mm, but I’ve also created a 90x90mm version. The horizontal surface slopes outwards by approximately 4° so that the water can run off towards the edge.
I printed the 70x70mm version on a Nextruder without supports.
Versions available:
70x70mm
with ball
without ball
90x90mm
with ball
without ball
My ASA print has come away slightly at the edges because I only used the brim only on the inside 🙄
Print Settings
Material: At least PETG; I used ASA
Layer height: 0,25mm, Structural Profile
Infill: 10% Grid
Perimeters: 3
Top Solid Layers: I used 5
Supports: I didn’t use supports for the 70x70mm version, 90x90 needs to be tested, but may also be working without.
Brim: Use mouse ears or Brim inside and outside.
The 3MF files with the ball are already configured with these settings.
If you found this useful please leave a make and/or a like or support me on Ko-Fi -Thank You!