1 / 3
Post Cover 70x70 and 90x90 — zdjęcie 1
1 / 3

Post Cover 70x70 and 90x90

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A post cap with a ball as a design element.

Ocena
0 / 5
Polubienia
3
Pobrania
5
Wydruki
0
Wyświetlenia
36
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

As I was missing a post cover, rather than buying one, I designed and printed one.
My post is 70x70mm, but I’ve also created a 90x90mm version. The horizontal surface slopes outwards by approximately 4° so that the water can run off towards the edge.
I printed the 70x70mm version on a Nextruder without supports.

Versions available:

  • 70x70mm

    • with ball

    • without ball

  • 90x90mm 

    • with ball

    • without ball

My ASA print has come away slightly at the edges because I only used the brim only on the inside 🙄

Print Settings

Material: At least PETG; I used ASA
Layer height: 0,25mm, Structural Profile
Infill: 10% Grid
Perimeters: 3
Top Solid Layers: I used 5
Supports: I didn’t use supports for the 70x70mm version, 90x90 needs to be tested, but may also be working without.
Brim: Use mouse ears or Brim inside and outside.

The 3MF files with the ball are already configured with these settings.

If you found this useful please leave a make and/or a like or support me on Ko-Fi -Thank You!

Tagi