Dropcam mount for Lowe's wire shelving 25mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I designed this as a mount for my Dropcam. If you print this, you may have to sand or file the tapered end of the…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 9
- Makes
- 0
- Views
- 100
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this as a mount for my Dropcam. If you print this, you may have to sand or file the tapered end of the plate a bit to get it to fit into the slot on the clamp.
There is no reason you could not print this in one piece. I just did it this way to make sure my perimeters were exact for my test print. As it turned out, the test print was good enough to just file a bit, then glue up and use.
You could also just print the plate to use for your own project.
update-I have uploaded a Booleaned one piece file too.
Instructions
Test fit the parts.
Sand or file as needed.
Insert the tab into the slot and superglue or epoxy it in.
Insert the dropcam.
Install clip onto the shelf uprights.
Aim and watch.
Category: Camera