1 / 9
Laundry Sheet Dispenser with Tear-in-Half Sleeve (Wall or Washer Mount) — image 1
1 / 9

Laundry Sheet Dispenser with Tear-in-Half Sleeve (Wall or Washer Mount)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

One laundry sheet at a time, exact halves on demand, and it hangs on a wall or a washer. Prints without supports.

Rating
0 / 5
Likes
0
Downloads
1
Makes
0
Views
4
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution

Wet hands plus a stack of loose sheets usually means you grab three and drip on the rest. This box hands them out one at a time instead.

The sheets lie flat inside. A gate across the bottom front leaves a gap just tall enough for one sheet. Reach under, press a thumb up through the hole on the bottom sheet, slide it toward you and pull it out of the slot. The rest of the stack stays where it is.

Doing a sink load or a hand wash? Slide a sheet into the sleeve on the right until it stops at 55 mm, which is exactly half of an 11 cm sheet. Fold it over the teeth and tear.

A window down the front has a refill line, so you find out the box is nearly empty before you're standing there with a full basket.

We designed it around Filthy Clean laundry detergent sheets, and it takes any 7 x 11 cm sheet: laundry, dishwasher or toilet.

What's in the files

  • Shell, wall plate, lid, gate and a small slider. The red tab on the front clicks through 8 notches that set the gap from 0.4 to 2.0 mm. Start on 5. Two sheets sneaking out together? Click it lower.

  • Mount it with two 4 mm countersunk screws, six 12 x 3 mm disc magnets for the side of a washer, or adhesive strips on the flat back.

  • PETG is the pick (PLA goes soft near a hot dryer). 0.2 mm layers, 3 walls, 15% infill, no supports. Every part fits a 180 mm bed and is exported in its print orientation.

  • 138 x 89 x 90 mm on the wall. Holds a full box of 80 sheets.

  • The 3MF has the logo as separate parts for multi-colour printers. The STL has it recessed.

Fresh design, and we haven't printed this one yet. If you do, post a make and tell us which notch suits your sheets.

Sheet Station by Filthy Clean, an Aussie-owned laundry sheet brand. CC BY 4.0, so remix away and keep the credit. The Filthy Clean name and logo aren't covered by the licence.

Tags