1 / 1
Rayven Talon Mag Adapter
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Converts your full-length Rayven magwell into a half-length Talon magwell easily!
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 1
- Makes
- 0
- Views
- 2
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
You will need talon-adapter-lever.stl and talon-adapter-lever-block.stl from the original model.
Supports recommended though not required, only the catch area.
Very low hardware requirements, pretty much only requiring some M3 screws and a spare full-length dart. Although the original model says you should use a pen spring, I found that cutting off the head of a full-length dart and using that as the lever spring worked just as well if not better. It also has the added benefit of being much easier to install.