Toyota Cressida Headlamp Adjuster Bearing (MX73, 1985-88)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement ball socket for the headlamp aiming screw on the 1985-88 Toyota Cressida. Prints without supports.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 0
- Makes
- 0
- Views
- 5
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
A 3D-printable replacement for the plastic ball socket of the headlamp aiming screw on the Toyota Cressida MX73 (US market, 1985–1988). It probably replaces Toyota 81153-22520 "Bearing, Headlamp" (from parts-catalog research, not confirmed on the car).
Status: v6, printed and tested: works well. Built from caliper measurements of a broken original from a 1985 US Cressida. Fit on other model years has not been checked. If your screw or printer is different, print the fork test piece first.
How it works
The part bolts to the back of the headlamp with an M6 stud. A Ø4 mm pin keys it to the lamp bracket so it cannot turn.
The aiming screw ends in a Ø8 mm ball that clicks into a cup in the fork (0.6 mm snap). Lips on the ball face (Ø6.0 opening) keep it from coming out.
Standard M6 hardware is fitted after printing: the nut slides into a side slot whose hex end stops it from turning. No print pause, no heat-set insert.
Printing (Ender-3 V3 SE, PETG)
0.12 mm layers, 4 walls, 100% infill.
No supports. The STL is already oriented with the fork tip on the bed.
8 mm outer brim with no gap. Cut the brim off; do not pry the prongs apart.
About 38 min and 4.5 g per part.
PETG softens at about 70–80 °C. ASA is the better choice next to a hot headlamp.
Hardware: 1× M6 nut (10 mm across flats, 5 mm thick), 1× M6 washer (about Ø12 × 1.6 mm), M6 threaded rod cut to 23.5 mm, blue threadlocker. The lamp nut from the old part is reused.
Assembly
Slide the nut into the side slot all the way to the end.
Put threadlocker on the rod, place the washer in the recess on the plate face, and screw the rod into the nut until 14 mm sticks out.
Fit the ball from the fork tip until it clicks. Never push it in from the ball face.
Mount the part on the lamp with the old nut: finger-tight plus a quarter turn. Check the headlamp aim after fitting.
The parametric OpenSCAD source is included. Notes and source on GitHub: github.com/huthaifa-foudeh/toyota-cressida-headlamp-bearing
