Riser and Hitch for IKEA ODDVALD Easel
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A riser and hitch for the IKEA ODDVALD easel. It rises 28 mm but I included the .SLDPRT for it to be modified.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 15
- Makes
- 0
- Views
- 374
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn't like the height of the table and needed a way to secure it, so I made a riser and hitch for the easel IKEA ODDVALD. This is the specific easen:
The model rises the height a total of 28 mm. The exacts dimensions of the model and how it fits to the easel can be check in the following pictures:
It also has a 6 mm hole in one side intended for a screw and a wing nut or other type of thumb screw to secure the board to the easel.
Since you may want to modify the model (especially the height), apart from the .STL I also included the SOLIDWORKS 2020 file.
Print Settings
Must be noted, that in order to assemble a whole table with two easels, you have to mirror the provided model. That is to say, in that case you will have to print:
- x2 “normal” ones.
- x2 mirrored ones.
In the following picture we can se an example for the pieces needed to assemble one easel:
Printed in PETG, without supports or rafts, at 0.2mm resolution and 50% infill.
For more strength you may want to lower the fan speed and increase the wall line count.
It also could be printed in PLA without a problem.
Assembly
Once you drilled the holes in the board, you need to slide the risers in the top part of the easel. Finally you insert the screws, put a washer and thigthen the whole thing with the wing nut.