IKEA Marcus office chair lift 40 mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Like many PC enthusiasts, I love the IKEA Markus chair. It has a tall back, quality mechanics, and is very ergonomic…
- Rating
- 0 / 5
- Likes
- 8
- Downloads
- 20
- Makes
- 0
- Views
- 500
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Like many PC enthusiasts, I love the IKEA Markus chair. It has a tall back, quality mechanics, and is very ergonomic for the price. However, I'm a tall guy, and it could be a bit higher for my taste. So I looked at the design and thought about where it could be raised up a bit. I discounted the mounting points for the rollers and for the central lift for strength reasons, and that only left mounting the seat cushion and the backrest higher.
This is an easy mod. You need to print 4 pieces of the round washer, and a single piece of the triple washer for the backrest. You also need 7 M8 hex bolts, length 70 mm (actually you'd need 5 in 60 mm and 2 in 80 mm, but I used a single length and it works well), to replace the old bolts that are now too short. I recommend using Loctite 243 thread locker, because that's what's on the original bolts as well, to keep the bolts tight.
UPDATE
I've been sitting on mine for almost a year now, and the mod is holding up just fine. Please pay attention to the printing instructions below.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.3 mm
Infill:
30% Cubic
Filament: any PETG or ABS black
Notes:
Print with many perimeters. I played around a bit, and going from 4 to 5 perimeters increased my print time by 30 minutes, which I think is worth it for the added strength. After all, there'll be up to 250 pounds sitting on it at all times.
Category: DIY