1 / 5
IKEA Marcus office chair lift 40 mm — zdjęcie 1
1 / 5

IKEA Marcus office chair lift 40 mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Like many PC enthusiasts, I love the IKEA Markus chair. It has a tall back, quality mechanics, and is very ergonomic…

Ocena
0 / 5
Polubienia
7
Pobrania
20
Wydruki
0
Wyświetlenia
494
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Like many PC enthusiasts, I love the IKEA Markus chair. It has a tall back, quality mechanics, and is very ergonomic for the price. However, I'm a tall guy, and it could be a bit higher for my taste. So I looked at the design and thought about where it could be raised up a bit. I discounted the mounting points for the rollers and for the central lift for strength reasons, and that only left mounting the seat cushion and the backrest higher.

This is an easy mod. You need to print 4 pieces of the round washer, and a single piece of the triple washer for the backrest. You also need 7 M8 hex bolts, length 70 mm (actually you'd need 5 in 60 mm and 2 in 80 mm, but I used a single length and it works well), to replace the old bolts that are now too short. I recommend using Loctite 243 thread locker, because that's what's on the original bolts as well, to keep the bolts tight.

UPDATE

I've been sitting on mine for almost a year now, and the mod is holding up just fine. Please pay attention to the printing instructions below.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

0.3 mm

Infill:

30% Cubic

Filament: any PETG or ABS black


Notes:

Print with many perimeters. I played around a bit, and going from 4 to 5 perimeters increased my print time by 30 minutes, which I think is worth it for the added strength. After all, there'll be up to 250 pounds sitting on it at all times.

Category: DIY

Tagi