Push2Twist Throttle Converter

Push / Thumb Throttle to Twist Throttle converter for e-scooters.

Tested on Honghao S12 with stock handlebar grips.

The interior diameter is 32mm for a tight fit between the margin of the handlebar grip and the slight middle bulge.

You can scale it using your slicing software to adapt to different requirements.

You can still use the throttle with your thumb while the converter is installed.

!!! Warning & Bonus functionality:

You must check the clearance between the converter and push throttle when not engaged. The push throttle must be able to return to the zero position. If any elements (ex. brake bracket, etc.) interfere with the throttle operation you may have to adjust their position slightly.

If you are worried that prolonged usage might damage your throttle lever you may use a small rubber band to wrap around the contact area on the lever or the converter. (maybe overkill as I was using it for more than a year without any visible damage)

When using the adapter the throttle may remain in the engaged position until you return it to the initial position.

You can use this as a form of cruise control on your own risk. You take full responsibility for using this adapter.

Version History:

• Push2TwistThrotleConverterV1.4.stl

Added a larger exterior rim and moved the rod to it for a better alignment with the push throtle. The interior has conical edges for easier instalation and smoother operation.

• Push2TwistThrotleConverterV1.1.stl

This version is sturdier, has rounded edges and takes about 1 hour to print at 0.2mm + adaptive layers

Print Settings

Printer Brand:

Anycubic

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2

Infill:

Category: Other