iFlight XL5 GPS Mast for M8Q-5883
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I made this small mast after finding that hard-mounting my GPS to the frame using this design…
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 42
- Makes
- 0
- Views
- 312
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution
I made this small mast after finding that hard-mounting my GPS to the frame using this design (https://www.thingiverse.com/thing:4057458) put it too close to the EMF of the controller/motors and threw off compass readings so iNav position hold would "toilet bowl". With the added height the GPS stands perfectly still!
This design includes 3 files, a mast, a GPS holder/cap, and a stiffener rod that can be printed in PLA or other rigid material to stiffen the mast (though I found at 90% infill it was stiff enough to fly). The mast and cap should be printed in TPU.
There are 2 holes in the mast, the larger one in the center is for the stiffener rod if needed while the second hole is to run your GPS/Compass wires so there isn't anything exposed. As with G3CK0_za's design, I recommend that you put a small piece of foam under the GPS unit to keep it held tight in the cap.
You'll also need:
- 4x M3 nuts
- 4x M3 x 12mm screws
- 4x M3 x 10mm screws (for mounting to drone frame, I used the ones that came with the frame)
Design files for Fusion 360 are included so feel free to remix for other frames/GPSs!
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.28
Infill:
90
Filament: NA TPU Blue
Notes:
You can print at a lower infill if you want but you may need to use the included stiffener rod. I found that I didn't even need the stiffener rod when I printed at 90/95% infill so FYI I haven't tested the fitment of the rod but it should be a snug fit.
Category: R/C Vehicles