1 / 5
Stock Ender 3/CR10 hotend mount/adaptor for CR10-V2/V3 — image 1
1 / 5

Stock Ender 3/CR10 hotend mount/adaptor for CR10-V2/V3

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

After much frustration and perseverance, I decided to ditch Creality's poor attempt at cloning an E3D V3 hotend, and…

Rating
0 / 5
Likes
27
Downloads
309
Makes
0
Views
3,111
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

After much frustration and perseverance, I decided to ditch Creality's poor attempt at cloning an E3D V3 hotend, and the terribly unfriendly housing that is a PITA if you need to access the hotend.

Using a fantastic model created by Siganberg I have adapted it to fit the carriage mounting points of the CR10-V2/V3, (and tweaked the internals somewhat) to allow you to use a standard Creality hotend (found on the Ender 3/Ender 5/Older CR10 variants) on the CR10-V2/V3, whilst using stock fans/front section of the stock housing.

This design requires a few additional fixings:

  • 2 x 16mm or 18mm M3 screws for mounting the hotend to the rear housing.
  • 2 x M3 nuts that are recessed into the rear housing.
  • 3 x M3 threaded inserts (pressed/melted into place in the three holes provided for attaching to the carriage assembly on the X-axis. Either use a soldering iron to heat the insert, or pliers and a flame)
  • 3 x 6mm M3 screws for mounting housing to the carriage assembly.

Both fans use stock screws and are what hold the two halves of the housing together.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

25%

Filament: SUNLU PLA White

Category: 3D Printer Parts

Tags