Stihl FS91 and FS31 Trimmer Wallmount
We calculate the final price from your selected file. You review and accept it before payment.
Preliminary estimate for PETG
€9.25 – €11.31 net (excluding VAT)
For file: FS91 Wall Hager V4_0.2mm_PETG_MINI_10h41m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €10.28 excluding VAT (range midpoint).
- Weight reported by the author
- 129 g
- Print time reported by the author
- 10.68 hr
- Source material
- PET
- Estimate material
- PETG
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Holds the trimmer upright on the wall for convenient storage
- Rating
- 5 / 5
- Likes
- 190
- Downloads
- 1,735
- Makes
- 12
- Views
- 7,157
- Reviews
- 8
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple but very sturdy wall mount for a FS91 and FS31 trimmer. It may fit other models as well with the same injection molded part around the upper driveshaft. I modeled this around my specific machine and you may need to scale it up to make yours fit properly. I highly suggest printing a test part with 10% infill to check the fit before you print with the settings below. Mount it with 3" to 3.5" #8 construction screws. Make sure you get the screws in a stud.
I have made a change to the part in the pictures. The hole for accessing the head of the upper screw was too small for a bit holder to pass through. I added more clearance so its easier to get the upper screw driven in.
Standard prusaslicer settings for a mini and prusament PETG with the following changes:
20% infill and 4 perimeters.
I think this would be a great part to print with a larger nozzle to cut down on the time, I just didn't feel like changing it out.