FLSUN SR - Fan Duct (Radial)

Description

The nozzle of the FLSUN SR is slightly longer than the focal point of the stock fan ducts, resulting in the airflow cooling the nozzle rather than the part / extruded filament.

Whilst this hasn't had a noticeable effect on the majority of prints, this may cause some issues with high angle overhangs or longer bridges, as well as small / thinner details on certain models.

This redesigned fan duct adjusts the focal point of the air flow by adjusting the angle and position relative to the nozzle. It offers close to 360 degree cooling at the cost of slightly lower pressure.

There is a small section removed due to the need to account for the off centre heat block.

---

Please note:

You will not be able to connect the included auto-level attachment with this duct attached.

Please ensure you level the bed and are happy with the result before installing this duct.

---

Print Settings:

• Ensure the model is rotated 90 degree as shown in the image for best results

• Brim - Yes

• Support - Yes

• Support Placement - Touching Buildplate

• Support Pattern - Lines

• Support Wall Line Count - 0.1

• Enable Support Brim - Yes

---

Looking for other options?

This duct is a part of a series with several options available to suit your needs

• FLSUN SR - Fan Duct (Narrow) https://www.thingiverse.com/thing:4896490

• FLSUN SR - Fan Duct (Ultra Narrow - Short) • RECOMMENDED • https://www.thingiverse.com/thing:4899374

• FLSUN SR - Fan Duct (Ultra Narrow - Long) https://www.thingiverse.com/thing:4899374

• FLSUN SR - Fan Duct (Radial) https://www.thingiverse.com/thing:4915578

• FLSUN SR - Fan Duct (Radial with Offset) https://www.thingiverse.com/thing:4916950

Print Settings

Printer:

FLSUN SR

Rafts:

Supports:

Yes

Resolution:

Infill:

15

Filament:

SUNLU PLA+

Black

Notes:

Category: 3D Printer Parts