Sliced Lithophane Lamp
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a replacement lamp shade for Northlight 36-4985. It should however work for any lamp to which where a 2.8 cm…
- Rating
- 0 / 5
- Likes
- 31
- Downloads
- 47
- Makes
- 0
- Views
- 529
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other House Equipment
- License
- Creative Commons — Attribution — Noncommercial
This is a replacement lamp shade forNorthlight 36-4985. It should however work for any lamp to which where a 2.8 cm lamp shade can be attached.
The lithophane slices can be replaced depending on holiday.
Lamp_holder_tighter.stl
Original design.
Lamp_holder_v2.stl
Less spacing between lithophane slices. Good if a very strong lightbulb is used.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
200
Infill:
40
Filament: PrimaValue PLA Black
Notes:
I used Build Plate Adhesion Type Brim to make it stand solid on build plate during printing.
Assemble
The Lithophane slices are a little bit bigger per design. Use a sandpaper to make the ends of them thinner and shorter so they fit snuggly. Do not use to much force when putting these in as they break easily.
You need to print 6 lithophane panels. Images should have following settings:
- Resolution of 5600x898, or similar aspect ratio.
- Borders fade to black.
How to:
- Slice and add borders fading to black using image editor.
- Upload images to https://3dp.rocks/lithophane/
- Go to Model Settings and use: *Maximum Size (MM) 230 *Thickness (MM) 2 *Border (MM) 2 *Thinnest Layer (MM) 0.7 *Vectors Per Pixel 6 *Base/Stand Depth 0 *Curve 180
- Go to Image settings and make sure you use Positive Image.
- Under model use Outer Curve.
- Download .stl file and print with white filament using following settings: *Infill 100 *Dynamic Quality 0.16mm *Build Plate Adhesion Type Brim
I usedExtrudr PLA NX2 White filament for slices.
Category: Decor