1 / 5
Universal Low-Profile Foldable Laptop Riser
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Legs that stick onto the bottom of your laptop to improve airflow for better cooling.
- Rating
- 5 / 5
- Likes
- 25
- Downloads
- 142
- Makes
- 2
- Views
- 1,073
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution — Share Alike
I liked flol3622's Legion Foldable Legs because the small hinges were surprisingly strong so I remixed it to stick to any laptop with some double sided tape.
Tolerances are a bit tight because of the small size so you may need to sand or file down some parts to fit.
Use included .3mf file in PrusaSlicer for custom supports. Print at high infill and wall count for better strength. Should take less than an hour to print (31 min on my modded Ender-5).
Required Materials:
- Double sided tape
- 1.75mm filament
- Needle file
Post Processing:
- Remove supports and poke thru the holes with a needle file
- Insert 1.75mm filament into the holes (Widen with needle file if the holes are too small)
- Chop off excess filament
- Apply double sided tape to base
- Clean bottom of laptop and stick on the legs