1 / 5
Cover for 1010Music Nanobox Lemondrop/Fireball synth — image 1
1 / 5

Cover for 1010Music Nanobox Lemondrop/Fireball synth

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

One-piece cover for a Nanobox to protect the screen when carrying. Space for the original cable inside.

Rating
5 / 5
Likes
2
Downloads
63
Makes
1
Views
757
Reviews
1

Updated at source:

Model information

Category
Music
License
Creative Commons — Attribution — Noncommercial — Share Alike

One-piece cover to protect your 1010Music Nanobox Lemondrop synth.

Or indeed your Fireball… but if you use it for that, sorry for the Lemondrop word embossed into it.

It clips over the top and is held in place by little clip shapes at the bottom. Flexible sides plus thumb holes make it easy to remove again.

I just wanted something to make me more likely to chuck my Lemondrop into a bag and take it with me. Makes it seem bigger, sure, but only really as tall as the synth's knobs without a case.

There is spare space inside for the USB-C power cable, but I won't lie, it's difficult! A shorter or thinner cable will go in there easily, but it is possible to reliably fit the original brightly coloured one with a bit of practice. The trick is to wind it in something closer to a flat spiral than you normally might. See the photo for my patented technique for this purpose: start by winding it round just two fingers a few times, then three fingers, then four - and you end up with a flatter coil of wire. Slide that in underneath the brackets which hold it in place.

Prints in PLA with no supports. 0.1mm layer height recommended to get nice smooth curves in the thumb holes.

Tags