Summer Waves Pool SFS Skimmer Adapter to Intex 1.5"
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is for a Polygroup Summer Waves 10ft pool with skimmer SFS400/SFS350 pump.
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 56
- Makes
- 0
- Views
- 1,846
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is for a Polygroup Summer Waves 10ft pool with skimmer SFS400/SFS350 pump.This will allow you to remove the pump assembly and install a upgraded pump and 1.5" hose. Version #1 uses the same 3.5mm thick 24.5mm inner diameter intake o-ring and mounting screws as the original assembly, and Version #2 uses the output o-ring instead.
Print in ABS if possible, but PLA will work well too. I also recommend applying few coats of clear acrylic sealer to the exterior and interior of the part to seal any wall holes. Applying a generous amount of Teflon Tape on the threads will also help seal it nicely.
Print the gasket using TPU, 35% Concentric infill.
The o-ring.stl file is just an add on, I wouldn’t recommend printing it. I suggest buying a silicone one from your local hardware store if the original o-rings are not available .
Print at high temps, approx (260C for ABS) or (230C for PLA) @100% extrusion, speed 20mm/s, 100% infill, use 8 for top, bottom, inner and outer walls to make it water tight and to prevent seepage, supports only needed for surfaces touching the bed.