1 / 2
Delta Calibration Piece
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
For measuring tower positions and radius errors on delta printers
- Rating
- 5 / 5
- Likes
- 8
- Downloads
- 113
- Makes
- 2
- Views
- 532
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Caibrate your delta printer's tower angles and radius errors with this test piece. A modified version of https://www.thingiverse.com/thing:745523 , it is best for use with Repetier firmware where the tower angles are measured from the X axis.
Test piece is 150mm diameter.
Print angles.pdf and line up the center of the print and the V slot with the X axis. Measure the angle errors of the towers. Tower lines are 120º apart. Each smaller graduation is 1º.
Radius errors can be made by measuring the outside of the blocks (67mm base length).