First Layer Calibration
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€0.11 – €0.14 net (excluding VAT)
For file: Mini-3x3in-calibration-test-v3_0.2mm_PLA_MINI_9m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €0.12 excluding VAT (range midpoint).
- Weight reported by the author
- 1 g
- Print time reported by the author
- 9 min
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Video link: https://rumble.com/vb9fxr-3d-printer-first-layer-calibration-process.html
- Rating
- 4.99 / 5
- Likes
- 1,795
- Downloads
- 24,294
- Makes
- 134
- Views
- 89,219
- Reviews
- 210
Updated at source:
Model information
- Source
- Printables
- Category
- Test Models
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Video link:
https://rumble.com/vb9fxr-3d-printer-first-layer-calibration-process.html
This is a 3 x 3 inch square used to help calibrate that oh so important first layer. This seems to be one of the most problematic asked about questions with new people to the 3d printer community. I decided to make a simple test part and video to show the process. Hope this helps!
(( There's a already sliced file for a Prusa Mini/Mini+ ))
((( Some have mentioned they need to run the calibration again when switching to a different material )))
Print instructions
If you can't use my gcode try to slice so it starts printing from the front and works backwards.
I would change the "fill angle" to 0(zero).
0.200mm layer height
PLA