Joel Telling of Additive Manufacturing 4.0
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
It seemed fitting to emboss a nozzle size of 4.0 - suggesting the standard 0.4mm scaled-up and alluding to Industry 4.0
- Rating
- 0 / 5
- Likes
- 1
- Downloads
- 9
- Makes
- 0
- Views
- 208
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Action Figures & Statues
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I chose to remix and print the 3dimensionz model, with the following adjustments:
- I embossed a 4.0 onto the nozzle and flattened its tip more to scale
- I added small discs between the fittings and the suit, where the base model seemed otherwise vulnerable to printing without supports.
- The clean-shaven face seemed an obvious oversight, but I clearly lacked the skills to add printable face fuzz, so that part of the remix needs more work by a talented modeler.
I was able to print this model on my CR6-SE with a 0.4mm nozzle, using Cura 14.3.1 Arachne Beta 2 to slice it at 0.12mm layer height (0.24mm initial layer height), 0.42mm line width, at 50mm/sec.
I used the Cura overlapping models feature to set the nozzle infill to 100%, while the rest of the figure was 25%. With 3 walls, the hose from case to suit printed without infill.
I used custom supports to hold the nozzle steady, blocked all support between the left boot and the case, and blocked all support from the waist-up, on the character.
It took approx 8hrs 44min to print.