Half-/Split-Cleat for Rope
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I needed a way to wrap up a lot of rope for a bike lift. The ceiling was so high that I ended up with way more rope…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 21
- Makes
- 0
- Views
- 255
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Office
- License
- Creative Commons — Attribution
I needed a way to wrap up a lot of rope for a bike lift. The ceiling was so high that I ended up with way more rope than the little included cleat could handle. So I threw together a quick split design.
Print two. Separate to the desired width. Screw in (to a stud or something else that's quite solid). Wrap yer rope. Yee haw!
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2mm layer height
Infill:
30%
Notes:
Print with one of the large sides facing down. Will be strongest and require no supports.
Note that using this orientation, it will split down the middle if you use a sloped-head wood screw, as the head of the screw will act as a wedge. If you do use a sloped-head screw, be sure to add a washer. I used #8 cabinet screws with standard M4 washers.
Category: Organization