Half-/Split-Cleat for Rope
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a way to wrap up a lot of rope for a bike lift. The ceiling was so high that I ended up with way more rope…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 255
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
I needed a way to wrap up a lot of rope for a bike lift. The ceiling was so high that I ended up with way more rope than the little included cleat could handle. So I threw together a quick split design.
Print two. Separate to the desired width. Screw in (to a stud or something else that's quite solid). Wrap yer rope. Yee haw!
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2mm layer height
Infill:
30%
Notes:
Print with one of the large sides facing down. Will be strongest and require no supports.
Note that using this orientation, it will split down the middle if you use a sloped-head wood screw, as the head of the screw will act as a wedge. If you do use a sloped-head screw, be sure to add a washer. I used #8 cabinet screws with standard M4 washers.
Category: Organization