Buck Converter Case
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A case to protect your buck converter from shorting out on the body of your 3D printer
- Rating
- 5 / 5
- Likes
- 44
- Downloads
- 332
- Makes
- 4
- Views
- 2,095
- Reviews
- 3
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed to hold a buck converter with an integrated display. These are the ones I used.
Its primary purpose is to protect from shorts on the back, and I was worried about heat, so there is no lid. There are cutouts for wires on either side, they'll need to be attached once the converter is installed into the case (with 4x M3 bolts).
The bottom has 4 pockets for M3 nuts. They're supposed to be a bit of a snug fit, some light persuasion was required with a rubber mallet for mine, but they are not so tight as to harm the case when you're installing them.
Recommended print settings:
- 0.16mm layer height
- 5 perimeters (prevents infill in the walls)
- 15% infill
- 5-7 top and bottom layers