Dasaki RAMPS32 for Mega, DUE, Re-ARM, GrandCentralM4
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This Dasaki case will fit the following MCU's: Arduino Mega 2560 Arduino DUE (not physically tested yet) Adafruit…
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 13
- Makes
- 0
- Views
- 175
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This Dasaki case will fit the following MCU's:
Arduino Mega 2560
Arduino DUE (not physically tested yet)
Adafruit Grand Central M4
Panucatt Re-ARM
It has plenty of height room for the MCU, RAMPS board, Step Stick Protectors, Step Sticks, and heat sink's
There is enough horizontal and vertical space to fit a new RAMPS 2.x 32bit board design and LCD adapters for Mega/Grand Central M4 and an extended Re-ARM LCD adapter.
Print Settings
Printer:
Piper2 CoreXY
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
15% to 30%
Filament:
SUNLU PLA
Notes:
4 top and bottom layers and 4 walls.
30% infill is good for the case and cover unless you want to use clear filament for the lid, then decrease to 15% infill. Case should remain at 30%.No supports are needed.
Both the case and cover is designed for a 60mm fan. Openings are walled off but cut out very easily.
Category: 3D Printing