1 / 4
Dasaki RAMPS32 for Mega, DUE, Re-ARM, GrandCentralM4 — zdjęcie 1
1 / 4

Dasaki RAMPS32 for Mega, DUE, Re-ARM, GrandCentralM4

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This Dasaki case will fit the following MCU's: Arduino Mega 2560 Arduino DUE (not physically tested yet) Adafruit…

Ocena
0 / 5
Polubienia
0
Pobrania
13
Wydruki
0
Wyświetlenia
175
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

This Dasaki case will fit the following MCU's:

Arduino Mega 2560

Arduino DUE (not physically tested yet)

Adafruit Grand Central M4

Panucatt Re-ARM

It has plenty of height room for the MCU, RAMPS board, Step Stick Protectors, Step Sticks, and heat sink's

There is enough horizontal and vertical space to fit a new RAMPS 2.x 32bit board design and LCD adapters for Mega/Grand Central M4 and an extended Re-ARM LCD adapter.

Print Settings

Printer:

Piper2 CoreXY

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

15% to 30%

Filament:

SUNLU PLA


Notes:

4 top and bottom layers and 4 walls.

30% infill is good for the case and cover unless you want to use clear filament for the lid, then decrease to 15% infill. Case should remain at 30%.

No supports are needed.

Both the case and cover is designed for a 60mm fan. Openings are walled off but cut out very easily.

Category: 3D Printing

Tagi