Raspberry Pi 4 - Simple Bumper
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Basic protection for your Raspberry Pi 4
- Rating
- 5 / 5
- Likes
- 30
- Downloads
- 162
- Makes
- 2
- Views
- 1,035
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Computers
- License
- Creative Commons — Attribution
This is a simple bumper case for your Raspberry Pi 3 or 4.
With the board screwed in place, the Micro SD card is protected, but you still have access to the slot. There are also support ledges around the outside, to stop the board from flexing if you press down on it. You can print it without supports, but the nut traps will be a bit ragged, so it's not recommended!
You'll need 4 M2.5 x 8mm screws, and 4 M2.5 nuts to secure the board.
Update: I have added a second version of the bumper with a notch cutout under the row of connector jacks as a couple of people have told me that some cables are a little tight because of the housings on the cables. This solves that issue.