Kettler Ping-Pong table wheel and joint
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Replacement joint and wheel assembly for a Kettler ping-pong table
- Rating
- 0 / 5
- Likes
- 15
- Downloads
- 162
- Makes
- 0
- Views
- 1,302
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Moin Moin, I designed a replacement joint and wheel assembly for a Kettler ping-pong table.
The original mounting hardware is needed (metal liner, hex bolt, washers)
Is in use for roughly two years now and is still holding up with no visible wear and tear.
The joint is printed out of Polymaker Polymax PC for extra stability.
Print Settings:
- 0.45mm Wall Line Width
- 270°C Print Temperatur
- 10 Wall Lines
- 100% Infill
- 40mm/s Print Speed
- 4mm Top/Bottom Thickness
- Part Cooling only until the support structure touches the part then completely turned off
- Supports on
- Printed with a Raft to combat the warping issues with Polycarbonate
I your joint is breaking under the load I recommend you try out remelting the part in salt.
The wheel and wheel hub are printed out of generic PETG.
Print Settings:
- 0.45mm Wall Line Width
- 8 Wall Lines
- 70% Infill
- Cubic Infill Pattern
- 40mm/s Print Speed
- 4mm Top/Bottom Thickness
- Part Cooling only until the support structure touches the part then completely turned off
- Supports on
I recommend you print the PETG Parts a few degrees celsius hotter than normal for extra layer adhesion.
The assembly can easily be modified with the provided Fusion360 (. f3d) files.