Dremel box organiser - Gridfinity based
We calculate the final price from your selected file. You review and accept it before payment.
Estimated printing price per file
€1.69 – €2.07 net (excluding VAT)
For file: Multipurpose Cutting Kit_0.2mm_PLA_MK3S_2h6m.gcode
This is an estimate for one file. You’ll confirm the exact price before ordering.
File and estimate settings
File used for this estimate
Average indicative estimate: €1.88 excluding VAT (range midpoint).
- Weight reported by the author
- 19 g
- Print time reported by the author
- 2.1 hr
- Source material
- PLA
- Estimate material
- PLA
- Estimate printer
- Bambu Lab P1S - 0.4 nozzle
- Estimate process
- 0.20mm Standard
Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.
Saved on this device.
Alternative organiser for the Dremel 8260 box set, instead of the original sponge. Gridfinity based!
- Rating
- 4.922 / 5
- Likes
- 1,476
- Downloads
- 4,525
- Makes
- 62
- Views
- 38,009
- Reviews
- 51
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial
I wanted to put all my Dremel accessories in the Dremel box, included in my new set, but the sponge inserts wasted soooo much space. So I decided to make it fit. First I tried to design a 4 piece design, but that would lack modularity, so redesigns would be a nightmare. Than I found the Gridfinity templates.
I made adapter plates fit in the box, and made holders to minimalize wasted space, caused by the grid's step size. Therefore some of the upper level tool holders need to be on the back edge of the grid, because they need the extra space. (And they not fit other gridfinity setups)
I printed all on PLA, no supports. You can save some filament, if you reduce the number of bottom layers, or the infill %.
The Dremel 8260 holder is needs a lot of refinement, it is wobbly it could be much better.
The “Box” is an optional filler, and only one of the two big disk holders needs to be printed.