1 / 8
Prusa MINI Z-Axis Brace for MGN12 Rails — image 1
1 / 8

Prusa MINI Z-Axis Brace for MGN12 Rails

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

A remix of Brolin Workshop's Z-Axis Brace with clearance for MGN12C linear rail blocks in the Y-Axis

Rating
5 / 5
Likes
47
Downloads
177
Makes
6
Views
1,556
Reviews
5

Updated at source:

Model information

License
Creative Commons — Attribution — Share Alike

This is a remix of the Prusa MINI Z-Axis Brace by Brolin Workshop with clearance for MGN12C blocks that I re-created from scratch for using with the Y-Axis Linear Rails Mod. It is inspired by a similar remix by Ryper3D.

The following things are different:

  • Clearance for an MGN12C or MGN12H block
  • A guide that slides into the Z extrusion to ensure perfect vertical alignment of the brace
  • Reinforced full-infill screw holes that withstand compression
  • More Prusa-like design by using big 4mm chamfers and 70-degree small chamfers instead of rounded corners and edges
  • STEP file available for easy remixing

Pro tip: To make installation easier with the bed still attached, remove the flex plate first. Then tilt the display out of the way and install the bracket loosely (just enough so you can still slide it around but as snug as possible) on the Y extrusion first, somewhere close to the display. Then slide it into position and loosely install it on the Z extrusion. Then fully tighten it on the Y extrusion using a ball-end allen key while lightly pressing it against the Z extrusion. Then fully tighten it on the Z extrusion.

When installed incorrectly, this bracket could tilt your Z-axis towards the front so it's important to first install it loosely so that it can still move a little and fully tighten all the screws afterwards.

BOM

QtyDescriptionSourcing
4M5x12mm Button Head Cap ScrewAliexpress, eBay
4M5 Drop-In T-Nut for 3030 Extrusions, Slot Type 8Aliexpress
4M5 10mm OD 1mm thickness nylon washer (optional)eBay

Printing

  • 4 Perimeters
  • 30 - 40% infill
  • 5 top and 5 bottom solid layers
  • PETG or better
  • STL is pre-rotated

Key Features

Assembly

  1. Install the M5x12mm screws, optional washers, and T-Nuts loosely on the Z-Brace
  2. Insert the Z-axis alignment guide into the T-slot of the Z extrusion
  3. Slide the brace down until it makes contact with the Y extrusion
  4. While keeping the brace aligned, tighten the M5 screws connected to the Z extrusion
  5. Tighten the remaining M5 screws on the Y extrusion

Tags